Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.

Thread Tools Search this Thread Display Modes
Old 09-29-2020, 08:04 AM
Capt Chuck's Avatar
Capt Chuck Capt Chuck is offline
Join Date: Aug 2003
Location: Sailfish Capital, fla
Posts: 2,682

I would glue the PVC down but screw the float switch & pump tray for easy removal. Another tip , attach some mono line with one drop of gorilla glue at the tip of the float switch. Bring the mono up and tie to anything under the deck with some slack. Then you just have to pull the mono to test your float switch without reaching all the way down into the bilge. The mono is light enough as not to weight down its buoyancy.
"Life is not a matter of holding good cards, but of playing a poor hand well."
-- Robert Louis Stevenson,

as "Americans" you have the right to ......
"LIFE, LIBERTY and the PURSUIT of a Classic SeaCraft" -- capt chuck
Reply With Quote
Old 09-29-2020, 08:07 AM
jorgeinmiami's Avatar
jorgeinmiami jorgeinmiami is offline
Senior Member
Join Date: May 2005
Location: Miami Fl
Posts: 1,372

Originally Posted by Capt Chuck View Post
I would glue PVC down but screw the float switch & pump tray for easy removal
That's what I did
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -4. The time now is 10:19 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
All original content 2003-2018 ClassicSeacraft